Back
Environment Product Guide

Information on regulation compliant storage of hazardous materials

The following information is intended to provide you with a short summary of the current regulations and requirements for lawful, compliant storage of water hazardous liquids and flammable liquids.

How to store flammable and water polluting liquids according to regulations

The storage of hazardous and dangerous substances is covered by the Control of Substances Hazardous to Health Regulations 2002 (COSHH). See http://www.hse.gov.uk/coshh/ Following risk assessment a number of control measures may be put in place to mitigate identified risks.

Installation and storage of sump trays

To protect groundwater, containers utilised for the storage of flammable or water hazardous liquids must be secured against leakage by means of an appropriate sump tray.
Sump trays should only be located on a flat surface under cover. In accordance with COSHH guidance, a sump tray must be able to accommodate the contents of the largest container or at least 10 % of the total quantity stored.

Example
Storage of 2 drums, each with 200 litre capacity

  • Overall storage quantity = 400 litres, of which 10 % = 40 litres
  • Largest container = 200 litres

Mandatory sump tray capacity = 200 litres

Note!
If the total volume of a hazardous chemical is large (CTC or IBC) the sump should be sized to contain 100% of the volume of the containers stored upon it.

Steel sump trays are suitable for the storage of flammable liquids in GHS categories 1 - 3 as well as water hazardous liquids in GHS categories 1 - 4.

PE sump trays are suitable for the storage of water hazardous liquids in GHS categories 1 - 4. Not approved for the storage of flammable media.

Information on regulation compliant hazardous goods storage and product guide wt$

Resistance of the materials

The corrosion resistance of the sump tray materials used and their suitability for use with the stored media must be certified. This is the user's responsibility. Please always observe the lists of resistant materials and safety data sheets (CHIP) for the material to be stored.

Tip
Unless otherwise stated in the list of resistant materials, the material for the sump can usually be the same as the material used to manufacture the storage container.

Classification / labelling of water hazardous liquids

Hazardous goods symbols for water hazardous liquids

The symbol below applies to Chemicals (Hazard Information and Packaging for Supply) Regulations 2009 - known as CHIP 4 or CHIP).

Information on regulation compliant hazardous goods storage and product guide wt$

Classification: severe water hazard | R set: - | Hazard category: WGK3
Classification: water hazard | R set: R 50, R 50/53, R 51/53 | Hazard category: WGK2
Classification: slight water hazard | R set: R 52/53, R 53 | Hazard category: WGK1

NEW according to GHS / REACH (effective 01/12/2010)

Information on regulation compliant hazardous goods storage and product guide 677

Classification: acute water hazard | H set: H 400 | Hazard category: GHS category 1

Classification: chronic water hazard | H set: H 410 | Hazard category: GHS category 1

Classification: chronic water hazard | H set: H 411 | Hazard category: GHS category 2

Classification: chronic water hazard | H set: H 412 | Hazard category: GHS category 3

Classification: chronic water hazard | H set: H 413 | Hazard category: GHS category 4

Classification / labelling of flammable liquids

Hazardous goods symbols for flammable liquids

The symbol below applies to Chemicals (Hazard Information and Packaging for Supply) Regulations 2009 - known as CHIP 4 or CHIP).

Information on regulation compliant hazardous goods storage and product guide wt$

Classification: highly flammable | Criteria: flash point < 0 °C, boiling point < 35 °C | R set: R 12

Classification: flammable | Criteria: flash point < 21 °C | R set: R 11, R 15, R 17

Classification: combustible | Criteria: flash point > 21 °C < 35 °C | R set: R 10

NEW according to GHS / REACH (effective 01/12/2010)

Information on regulation compliant hazardous goods storage and product guide 675

Classification: highly flammable | Criteria: flash point < 23 °C, boiling point < 35 °C | H set: H 224 | Hazard category: GHS category 1

Classification: flammable | Criteria: flash point < 23 °C, boiling point > 35 °C | H set: H 225 | Hazard category: GHS category 2

Classification: combustible | Criteria: flash point > 23 °C < 60 °C | H set: H 226 | Hazard category: GHS category 3

Additional hazardous goods symbols (GHS)

Information on regulation compliant hazardous goods storage and product guide 673

Corrosive (C)

Information on regulation compliant hazardous goods storage and product guide 679

Poisonous (T)

Highly poisonous (T+)

This information applies only to Germany, is not liable for completeness and is not binding. As a general rule, please observe local regulations. Your local authority will be able to provide detailed information.

Guide to hazardous goods storage

In order to make it easier to select the right product for your application, we have incorporated a hazardous goods storage guide for the respective products:

In reference to suitability and resistance requirements, the hazard symbols for various media to be stored are shown below (these symbols can also be found on hazardous material containers).

Regarding certification, the logos for the relevant test certificates are also shown.

Certifications

Information on regulation compliant hazardous goods storage and product guide 646
Information on regulation compliant hazardous goods storage and product guide 711

American (U.S.A) test certificates

Information on regulation compliant hazardous goods storage and product guide 665

Environmental Protection Agency

Information on regulation compliant hazardous goods storage and product guide 692

Occupational Safety & Health Agency / National Fire Protection Agency

Information on regulation compliant hazardous goods storage and product guide 724

Uniform Fire Code

Information on regulation compliant hazardous goods storage and product guide 669

Factory Mutual (independent testing agency)

Glossary of terms and abbreviations used

ADR / RID
Regulations for international transport of hazardous material by rail and road


BetrSichV
Company safety directive


DIBt
German Institute for Construction Technology


GGVSEB
Regulations for transporting hazardous material by rail, road and inland waterway


GHS
Globally Harmonized System of Classification and Labelling of Chemicals. Standardised international system for the classification and labelling of chemicals (substances and mixtures).

IBC / CTC
Intermediate Bulk Container / Cubic Tank Container
Internationally approved bulk packaging containers for hazardous liquids


StawaR
Steel sump directive (up to 1000 litres)


TRbF
Technical regulations for combustible liquids


TRG
Technical regulations for compressed gases


ADR / RID
Regulations for international transport of hazardous material by rail and road


ÜHP
Manufacturer's declaration of conformity following product testing by a recognised institution